質量**是生命！我們所有產品都經過全面質量評測，檢測手段有來料熔體指數，強度，粘度和沖擊強度數據評估。我們也有健全的研究和開發部門，不斷的改性和改進產品性能，達到客戶的特殊要求。   

線條直徑的控制是生產控制的重要指標，在生產過程我們針對線條產品直徑的監控，有在線實時反饋電腦系統和歷史記錄、查詢功能，保證每一卷線條每一個點的直徑都是可視化，力求產品**合格。

經過幾年的發展，我們形成了產品標準化，質量標準化，包裝標準化，出貨標準化，全面的標準化生產和管理，為客戶供應標準化和一致性的產品。

Quality is a top priority! ?? All of our products receive a full quality assessment as part of our production process. ?? We run analysis on melt index, strength, elaticity as well as testing impact tolerances. ?? We also have a full research and development department. ?? This group is ready to modify/improve the properties of our standard products to match your company's specific needs.

Diameter is important controled index, we have show the diameter data on line and computer feed back,historial recorder and inquiry, aim to make diameter data of each roll and each point of line can be seen and detected, and ** qulified.

In the past some years, we built products standard,qulity standard,packaging standard,shipping standad,total standard produce and managerment, supply customers with standard and consistent products.

圓度控制 Roundness control

直徑監控系統 Diameter monitor system

為了線條的直徑控制，我們有如下3種措施：For the diameter control, we have 3 methods:

1.我們要求工人每卷包裝完整的線條外再繞一小圈樣品可供工人手工再次檢測。.

2.每當直徑超過設定上下極限值時，測徑儀會發出警報聲，以提示技術工人對擠出系統調整，以使線條直徑再次恢復到合格水平。

3.我們將每卷直徑數據存儲在電腦內，每天超過10萬條數據以日期為命名存儲為excel文件，我們可以隨時調出以統計和分析問題，我們可以根據客戶反饋問題而直接追溯到生產**手數據。

         
     ;